Structural Design Specifications Online Test – Multiple Choice Questions and Answers Posted on April 16, 2024April 16, 2024 by engineer1 Comment 1. The spans of filler joists supporting a slab may be considered approximately equal if the longest span does not exceed the shortest span more than 5% 10% 15% 25% 2. Removal of props under slabs spanning upto 4.5 m is 14 days beams spanning upto 6 m is 14 days slabs spanning upto 4.5 m is 7 days All the above 3. Pick up the correct statement for the web stiffeners d is the distance between flange angles or the clear distance between flanges vertical stiffeners are spaced at a distance not greater than 1.5 d and not less than 0.33 d for horizontal stiffeners, d is the clear distance between the horizontal stiffener and the tension flange all the above 4. All reinforcement should be free from paints loose rust loose mill scales All the above 5. Pick up the correct statement from the following: The minimum pitch of rivets should not be less than 2.5 times the diameter of the rivet hole The distance between centres of two adjacent rivets in line with the direction of stress shall not exceed 16 t or 200 mm whichever is less in tension members The distance between the centres of two adjacent rivets in line with the direction of stress shall not exceed 12 t or 203 mm whichever is less in compression members All the above 6. The anchorage value of standard U-type hook of a reinforcing bar of diameter d in tension, is 4 d 8d 12 d 16 d 7. The permissible bending stresses Pbet for steel slab bases should not exceed 1500 kg/cm2 1650 kg/cm2 1800 kg/cm2 1890 kg/cm2 8. Pick up the correct statement from the following: For steel castings, the minimum tensile strength is 41 kg/mm2 and minimum yield stress is 20.5 kg/mm2 For high tensile steel, the minimum tensile strength is 58 kg/mm2 For mild steel the minimum tensile strength is 44 kg/mm2 and minimum elongation of 23% on a gauge length of 5.65A All the above 9. Moist sand may contain surface water by mass upto 1.25% 2.5% 5.0% 7.5% 10. Pick up the correct statement from the following: The diameter of a rivet, before driving is taken as the nominal diameter of the rivet The diameter of the rivet hole is taken as the gross area of the rivet For rivets of nominal diameters less than 25 mm, the diameter of the rivet hole is taken as the nominal diameter of the rivet plus 1.5 mm All the above Loading … Question 1 of 10
HONESTLY YOU HAVE DONE A VERY GOOD WORK HERE BUT I WANT TO PLEAD TO YOU TO SEND ALL THESE INTERVIEW QUESTIONS AND ANSWERS TO ME IN PDF FORMAT Reply
![MCQs [2024]](https://engineeringinterviewquestions.com/wp-content/uploads/2021/02/Interview-Questions-2.png)
HONESTLY YOU HAVE DONE A VERY GOOD WORK HERE BUT I WANT TO PLEAD TO YOU TO SEND ALL THESE INTERVIEW QUESTIONS AND ANSWERS TO ME IN PDF FORMAT