Advanced Engineering Geology Questions and Answers on “Causes of Mass Movements – 02”.
1. Which of the following is not a failure due to the role of water?
a) Increase in pore pressure
b) Accumulation of water at the back of the rock
c) Accumulation of water at the front of the rock
d) Lubrication effect of the rock mass
Answer: c
Clarification: The various causes of rock mass due to the role of water are: Increase in pore pressure, accumulation of water behind the rock mass, lubrication of water etc. Water cannot get accumulated in front of the rock and if it does happen in some conditions, it does not contribute greatly to the failure.
2. The rock which can be stable even with vertical slopes is __________
a) Sandstone
b) Granite
c) Shale
d) Chalk
Answer: b
Clarification: Crystalline igneous rocks like granites and gabbros and massive metamorphic rocks like marbles, quartzites and gneisses may be stable even with vertical slopes, whereas the same cannot be said about chalk.
3. Which type of sandstone is more stable?
a) Cemented with siliceous material
b) Cemented with argillaceous material
c) Cemented with ferruginous material
d) Cemented with calcareous material
Answer: a
Clarification: Sandstones for instance, occur in a great variety of types. Fine textured, dense and massive sandstones with siliceous cements may be very stable even at vertical slopes whereas the same rock with ferruginous, calcareous and clayey cements may become unstable at angle of 60° or even less.
4. What can be said about stability of slope when the layers are horizontal?
a) Stable up to 45°
b) Stable at all angles up to 90°
c) Unstable up to 45°
d) Unstable at all angles up to 90°
Answer: b
Clarification: The layers horizontal layers: Such rocks forming the slopes of the natural valleys and artificial cuts are stable at all angles up to 90°. When they fail, it may be due to the presence of secondary jointing or related fractures.
5. What has to be considered while giving cuts in stratified rocks?
a) Risk factor
b) Complication factor
c) Safety factor
d) Dip factor
Answer: d
Clarification: The dip factor has to be kept in mind while giving cuts in stratified rocks. it may be possible to explain that cuts parallel to the dip of the rocks are more safe and stable compared to those parallel to the strike of layers.
6. In metamorphic rocks derived from stratified sedimentary rocks, the direction of cleavage with respect to the original bedding may cause a complex system of weak planes.
a) True
b) False
Answer: a
Clarification: In metamorphic rocks derived from stratified sedimentary rocks, the direction of cleavage with respect to the original bedding may cause a complex system of weak planes. As such slips may be of common occurrence in the slopes made of the above metamorphic rocks.
7. Which zones are most potential surfaces for rock slips?
a) Smooth surfaces
b) Rough surfaces
c) Shear zones
d) Tensile zones
Answer: c
Clarification: Shear zones are most potential surfaces for rock slips, especially when lubricated with water due to soft character of the shear zone material.
8. Which of the following is an external factor for failure?
a) Composition of the mass
b) Role of water
c) Geological structures
d) Removal of vegetation
Answer: d
Clarification: Removal of vegetation cover especially trees is an external factor that has been a contributive factor in causing slope failures in a large number of cases, including the notorious Nashri Slide near Ramban on National Highway-1 in Jammu Kashmir.
9. Majority of rocks are free from joints and cracks.
a) True
b) False
Answer: b
Clarification: A very few rocks are free from the structures like cracks and joints which may occur due to tension, compression or shear to which these rocks have been subjected since their formation.
To practice Advanced questions and answers on all areas of Engineering Geology,