a) 3.75 m
b) 4.0 m
c) 4.2m
d) 4.5m
Ans: c
Category: FLUID MECHANICS Questions
The pitot tube is used to measure | FLUID MECHANICS
a) velocity at stagnation point
b) stagnation pressure
c) static pressure
d) dynamic pressure
Ans: b
Select the incorrect statement. | FLUID MECHANICS
a) The pressure intensity at vena contracta is atmospheric.
b) Contraction is least at vena contracta.
c) Stream lines are parallel throughout the jet at vena contracta.
d) Coefficient of contraction is always less than one.
Ans: c
300+ TOP FLUID MECHANICS Multiple Choice Questions and Answers
100 TOP FLUID MECHANICS Multiple Choice Questions and Answers pdf<—– CLICK HERE
91. The length of a pipe is 1 km and its diameter is 20 cm. If the diameter of an equivalent pipe is 40 cm, then its length is
a) 32 km
b) 20 km
c) 8 km
d) 4 km
Ans: a
92. Two pipes of same length and diameters d and 2d respectively are connected in series. The diameter of an equivalent pipe of same length is
a) less than d
b) between d and 1.5 d
c) between 1.5 d and 2d
d) greater than 2d
Ans: a
93. The horse power transmitted through a pipe is maximum when the ratio of loss of head due to friction and total head supplied is
a) 1/3
b) 1/4
c) 1/2
d) 2/3
Ans: a
94. The boundary layer thickness at a distance of l m from the leading edge of a flat plate, kept at zero angle of incidence to the flow direction, is O.l cm. The velocity outside the boundary layer is 25 ml sec.
The boundary layer thickness at a distance of 4 m is
a) 0.40 cm
b) 0.20 cm
c) 0.10 cm
d) 0.05 cm
Assume that boundary layer is entirely laminar.
Ans: b
95. Drag force is a function of
i) projected area of the body
ii) mass density of the fluid
iii) velocity of the body
The correct answer is
a) (i) and (ii)
b) (i) and (iii)
c) (ii) and (iii)
d) (i), (ii) and (iii)
Ans: d
Centre of buoyancy always | FLUID MECHANICS
a) coincides with the centre of gravity
b) coincides with the centroid of the volume of fluid displaced
c) remains above the centre of gravity
d) remains below the centre of gravity
Ans: b
When the velocity distribution is uniform over the cross-section, the correction factor for momentum is
a) 0
b) 1
c) 4/3
d) 2
Ans: b