1. Which of the following conditions are needed to properly bias an npn transistor amplifier?
2. To get a negative gate-source voltage in a self-biased JFET circuit, you must use a
3. Three different points are shown on a dc load line. The upper point represents the
4. In order for feedback oscillators to have any practical value, the gain has to be
5. The depletion-mode MOSFET
6. In a class B push-pull amplifier, the transistors are biased slightly above cutoff to avoid
7. Often a common-collector will be the last stage before the load; the main function of this stage is to
8. A JFET
9. The capacitor that produces an ac ground is called a(n)
10. The primary function of the bias circuit is to
Question 1 of 10