Machine Kinematics Multiple Choice Questions on ” Mechanisms with Lower Pairs”.
1. A pantograph consists of
a) 4 links
b) 6 links
c) 8 links
d) 10 links
Answer: a
Clarification: In a pantograph, all the pairs are turning pairs. It has 4 links.
2. Which of these mechanisms gives an approximately straight line?
a) hart
b) watt
c) peaucellier
d) tchebicheff
Answer: b
Clarification: Watt’s mechanism is a crossed four bar chain mechanism and was used by Watt for his early steam engines to guide the piston rod in a cylinder to have an approximate straight line motion.
3. Which of these mechanism has six links?
a) tchebicheff
b) hart
c) peaucellier
d) watt
Answer: b
Clarification: Hart’s mechanism requires only six links as compared with the eight links required by the Peaucellier mechanism.
4. Which of these mechanisms use two identical mechanisms?
a) hart
b) watt
c) peaucellier
d) none of the mentioned
Answer: d
Clarification: None.
5. The Davis steering gear is not used because
a) it has turning pairs
b) it is costly
c) it has sliding pair
d) it does not fulfil the condition of correct gearing
Answer: b
Clarification: Though the gear is theoretically correct, but due to the presence of more sliding members, the wear will be increased which produces slackness between the sliding surfaces, thus eliminating the original accuracy. Hence Davis steering gear is not in common use.
6. The Davis steering gear fulfils the condition of correct steering at
a) two positions
b) three positions
c) all positions
d) one positions
Answer: c
Clarification: It can be used in all positions.
Ackermann steering gear fulfils the condition of correct steering at only three positions.
7. The Ackermann steering gear fulfils the condition of correct steering at
a) no position
b) one position
c) three positions
d) all positions
Answer: c
Clarification: Ackermann steering gear fulfils the condition of correct steering at only three positions.
8. A Hooke’s joint is used to join two shafts which are
a) aligned
b) intersecting
c) parallel
d) none of the mentioned
Answer: b
Clarification: Hooke’s joint is used to connect two shafts, which are intersecting at a small angle.
9. The maximum velocity of the driven shaft of a Hooke’s joint is
a) ω1 cosα
b) ω1/cosα
c) ω1 sinα
d) ω1/sinα
Answer: b
Clarification: Maximum speed of the driven shaft,
ω1(max) = ωcosα/ 1 – sin2α = ωcosα/cos2α = ω/cosα.
10. The maximum velocity of the driven shaft of a Hooke’s joint is at ϴ equal to
a) 00 and 1800
b) 900 and 2700
c) 900 and 1800
d) 1800 and 2700
Answer: a
Clarification: Maximum velocity is determined at 00 ,1800 and 3600.