Engineering Metrology Multiple Choice Questions on “Alignment Tests on Lathe”.
1. What is the purpose of locating cylinder in the test of the true running of the main spindle?
a) To locate the chuck
b) To locate the main spindle
c) To locate the feeler
d) To level the machine
Answer: a
Clarification: Locating cylinder is provided to locate the face plate or chuck. Threads get worn out soon thus, locating surface can not be threaded one. Locating surface should be cylindrical and must run truly.
2. In what direction the parallelism of the main spindle to saddle movement is checked?
a) Vertical direction
b) Horizontal direction
c) Both vertical and horizontal direction
d) At an angle
Answer: c
Clarification: Parallelism of the main spindle to saddle movement is checked in both vertical and horizontal direction. In this method, mandrel is used and this mandrel should be so proportioned that its overhang does not produce sag.
3. What is axial play?
a) Freedom of spindle movement in axial direction
b) Freedom of spindle movement perpendicular to axial direction
c) Freedom of spindle movement in direction of cutting forces
d)Freedom of spindle movement in horizontal direction
Answer: a
Clarification: Meaning of axial play is the indispensable freedom of movement of spindle in the axial direction to prevent it from seizing by heating. It is different from axial slip. Axial slip is the axial movement of spindle which follows the same pattern.
4. What will happen if an axial play is not provided to the spindle?
a) It will try to expand
b) It will try to bend
c) It will shrink in some time
d) It will show fracture
Answer: b
Clarification: If axial play is not allowed, it would try to bend. Thus there will be no adverse effect of axial play if the direction of cutting forces remains constant or same. If this direction of cutting force changes, there would be some error introduced due to axial movement of spindle.
5. In leveling of machine, which direction is more important in horizontal plane?
a) Longitudinal
b) Transverse
c) Both longitudinal and transverse
d) Both longitudinal and transverse direction is not important
Answer: c
Clarification: Both longitudinal and transverse directions are equally important in horizontal plane. It will produce a simple bend and undesirable stresses; if any long lathe bed is not installed truly horizontal then there will be a deflection in bed.
6. What is the effect of axial slip in screw cutting?
a) Pitch will not be uniform
b) Pitch will be uniform
c) Pitch will be short
d) Pitch will be high
Answer: a
Clarification: Due to the axial slip, the pitch will not be uniform in the case of screw cutting. It is due to periodic movement of the spindle. However this is not of so much importance while turning.
7. Which of the following is done for testing the true running of headstock centre?
a) Feeler of dial indicator is pressed perpendicular to the taper surface
b) Feeler of dial indicator is pressed parallel to the taper surface of cent
c) Feeler of dial indicator is pressed at acute angle to the taper surface of cent
d) Feeler of dial indicator is pressed at obtuse angle to the taper surface of cent
