VLSI Multiple Choice Questions on “BiCMOS Inverters”.
1. In BiCMOS, bipolar transistors are used to ___________
A. drive input loads
B. drive output loads
C. to perform logic functions
D. to amplify the input voltage
Answer: B
Clarification: In BiCMOS, bipolar transistors are used to drive output loads. Bipolar transistor can also be used as amplifier, switch or as an oscillator.
2. In BiCMOS, MOS switches are used to __________
A. drive input loads
B. drive output loads
C. to perform logic functions
D. to amplify the input voltage
Answer: C
Clarification: In BiCMOS circuits, MOS switches are used to perform logic functions. The ability to turn the power MOS “ON” and “OFF” allows the device to be used as a very efficient switch with switching speeds much faster than standard bipolar junction transistors.
3. The nMOS and pMOS transistors used in BiCMOS is ____________
A. depletion mode
B. enhancement mode
C. only pMOS
D. only nMOS
Answer: B
Clarification: The nMOS and pMOS transistors used in BiCMOS device operates in enhancement mode. Enhancement mode devices are mostly common switching elements in MOS.
4. The inverter has __________
A. low input impedance
B. high input impedance
C. high output impedance
D. high input and output impedance
Answer: A
Clarification: The inverter has low input impedance. The basic inverter circuit requires a transistor with source connected to ground and a load resistor connected from the drain to positive supply Vdd.
5. The inverter has __________
A. low output impedance
B. low input impedance
C. low power dissipation
D. high input and output impedance
Answer: A
Clarification: The inverter has low output impedance and low input impedance. These are some of the properties of a BiCMOS inverter.
6. The inverter has __________
A. high current driving capability
B. occupies smaller area
C. high noise margin
D. all of the mentioned
Answer: D
Clarification: The inverter has high current driving capability, occupies smaller area and has high noise margins.
7. Output voltage swing should be reduced for a better performance of BiCMOS circuit.
A. true
B. false
Answer: A
Clarification: For a better performance BiCMOS circuit, the output voltage swing should be reduced. The possible maximum output peak-to-peak voltage obtained without clipping is called as output voltage swing.
8. BiCMOS inverter requires high load current sourcing.
A. true
B. false
Answer: A
Clarification: BiCMOS inverter needs high load current sinking and sourcing. Sinking provides a grounded connection to the load, whereas sourcing provides a voltage source to the load.
9. BiCMOS has _______ standby leakage current.
A. higher
B. lower
C. very low
D. none of the mentioned
Answer: A
Clarification: BiCMOS has higher standby leakage current and thus has high power consumption.
10. For improved base current discharge ________ enhancement type nMOS devices have to be added.
A. two
B. three
C. one
D. four
Answer: A
Clarification: For improved base current discharge, two enhancement type nMOS transistors have to be added.
11. The BJTs in the BICMOS circuit is in _____________ configuration.
A. Push-pull
B. Totem pole
C. Active high
D. Active low
