Engineering Physics Objective Questions & Answers focuses on “Diode as a Rectifier”.
1. If a rectifier has 2 diodes it is a __________
a) Quarter-wave rectifier
b) Half-wave rectifier
c) Full-wave rectifier
d) Peak-to-peak rectifier
Answer: c
Clarification: A full-wave rectifier requires at least 2 diodes. If only one junction diode is used, then the wave would be only half rectified. The two diodes are connected in such a way, that when one diode is forward biased the other would be reverse biased.
2. How does the frequency of the wave changes when the wave has been half-rectified?
a) Doubles
b) Halves
c) One-fourth
d) Remains same
Answer: d
Clarification: After the wave has been half-rectified, the frequency of the wave remains same. When the wave has been fully rectified, then the frequency doubles.
3. In a full-wave rectifier, at a certain point of time, what is the biasing of both the diodes?
a) When one is Forward biased, other is Reverse biased
b) Both forward biased
c) Both reverse biased
d) Can’t be predicted
Answer: a
Clarification: In the case of a full-wave rectifier, the two diodes are connected such that when one diode is forward biased, the other one would be reverse biased.
4. After rectifying the wave, the output voltage does not vary.
a) True
b) False
Answer: b
Clarification: After a wave has been rectified, the output voltage, though still varying, is restricted to only one direction. The frequency of the wave remains the same.
5. Which device is used to get a steady DC output?
a) Battery
b) Zener Diode
c) Resistor
d) Capacitor
Answer: d
Clarification: Though the rectified voltage is unidirectional, it does not have a steady value. To get steady DC output from the pulsating voltage normally a capacitor is connected across the output.
6. Which of the following is not a use of Rectifier Diode?
a) Voltage Reference
b) Detection signals
c) Voltage regulator
d) LASER diodes
Answer: c
Clarification: Rectifier diode is used for Voltage reference, detection signals and LASER diodes as well. Zener Diode is used as a voltage regulator.
7. The rectifier diode is a non-ohmic device.
a) True
b) False
Answer: a
Clarification: The current-voltage curve of a rectifier diode is not a straight line. Thus, it does not obey Ohm’s law and is a non-ohmic device.
8. How would the following wave be half-wave rectified?
a)
b)
c)
d)
Answer: c
Clarification: When the given wave would be fed into a rectifier, all the output would be restricted to only one direction.
