Engineering Metrology Multiple Choice Questions on “Principle of Working”.
1. What is the use of a laser beam in image formation?
a) Triangulation system for measuring system
b) Reduce glare of image
c) Controls contrast of image
d) Controls brightness of image
Answer: a
Clarification: Laser beam is used for triangulation system for measuring distance. Polarised or ultraviolet light is used to reduce glare or increase contrast. It is important that light source is placed correctly since it influences the contrast of the image.
2. Where is backlighting is best suited?
a) Simple silhouette image is required to obtain minimum image contrast
b) Certain key features on the surface of the object are to be inspected
c) Simple silhouette image is required to obtain maximum image contrast
d) Three-dimensional feature is being inspected
Answer: c
Clarification: Backlighting is suited when a simple silhouette image is required to obtain maximum image contrast. When certain key features on the surface of the object are to be inspected, front lighting is used.
3. Which light is preferred if three dimensional features are being inspected?
a) Front lighting
b) Side lighting
c) Backlighting
d) Any lighting is suited
Answer: b
Clarification: Side lighting or structured lighting may be required when a three-dimensional feature is being inspected. The proper orientation and fixturing of part also deserve full attention. Selection of proper illumination technique is important for any feature.
4. Why do CCD or CID cameras are used?
a) To generate the electronic signal representing the image
b) To generate image’s hard copy
c) To determine lighting of the image
d) To capture heat signature
Answer: a
Clarification: CCD or CID cameras are used to generate the electronic signal that represents the image. The camera collects light from the image scene via lens and uses a photosensitive target to converts it into electronic signal.
5. Where is the Vidicon Camera used?
a) Open-circuit television systems
b) In Image processing
c) In image analysis
d) Closed-circuit television systems
Answer: d
Clarification: Vidicon Camera used in closed-circuit television systems can be used for machine vision systems. An image is formed in camera by focussing the incoming light through a series of lenses onto the photoconductive faceplate of the vidicon tube.
6. What is used in solid state cameras?
a) Image sensor IC
b) CMOS image sensors
c) Charge coupled device (CCD) image sensors
d) Digital camera image sensor
Answer: c
Clarification: Solid state cameras are generally used in machine vision systems. These uses charge injected device (CID) or charge coupled device (CCD) image sensors. They contain linear or matrix array of small, accurately spaced photo-sensitive elements fabricated on silicon chips using integrated circuit technology.
7. How many detector elements are present in a matrix array solid state camera?
a) 156 x 156 per array
b) 216 x 216 per array
c) 116 x 116 per array
d) 256 x 256 per array
Answer: d
Clarification: A typical matrix array solid state cameras have 256 x 256 detector elements per array. Solid state cameras are small and rugged. Sensors of solid state cameras are do not wear out with use. There is very less image distortion in solid state cameras because of placement of photo detectors accurately.
8. What is the common rate of an image forming in a camera?
a) 20 images per second
b) 30 images per second
c) 25 images per second
d) 50 images per second
