Statistical Quality Control Multiple Choice Questions on “Attribute Control Charts – Choice between Attributes and Variable Control Charts – 2”.
1. Which of these is a condition where attributes control charts should be used?
a) New product manufacturing from existing process
b) Troubleshooting a out-of-control process
c) When it is necessary to reduce process fallout
d) Change in product specification is required
Answer: c
Clarification: When it is necessary to reduce process fallout, and when the operators control the assignable causes, Attributes control charts are chosen over the Variables control chart.
2. When the process is a complex assembly operation, and the product quality can only be judged in terms of occurrence of nonconformities, the ______ are more helpful.
a) Only x Charts
b) R-charts
c) s-charts
d) p-charts
Answer: d
Clarification: When the process is a complex assembly operation and the product quality is assessed only on basis of occurrence of defects, the p-charts are more helpful.
3. When process needs to be controlled but the measurement data cannot be obtained, the control charts to be formed are _____________
a) p-charts
b) Only x Charts
c) s-charts
d) R-charts
Answer: a
Clarification: When process needs to be controlled but the measurement data can’t be acquired, the attributes charts are the better choice than the variables control chart.
4. When there are very tight specifications, overlapping assembly tolerances problems, which of the control charts are used?
a) Attributes control charts
b) Variables control charts
c) Both, attributes control charts and the variables control charts can be used
d) Neither one of attributes or variables control charts can be used
Answer: b
Clarification: Variable control charts are more favored when there are very tight specifications, overlapping assembly tolerances problems. This is because variables control charts deal better with specifications of quality characteristics than the attributes control chart.
5. When destructive testing is required, which type of control should be used?
a) p-chart
b) c-chart
c) x And R charts
d) u-charts
Answer: c
Clarification: When destructive testing is required or any other expensive testing procedure is needed, variable control charts are more suitable than the attributes control chart.
6. When attributes charts are used when _______
a) Destructive testing is required
b) Process must be continuously stabilized and monitored for its capability
c) Historical summary of process performance is needed
d) Existing process but in chronic trouble
Answer: c
Clarification: When historical summary of process performance is needed for the variables control charts, attributes control charts are used to develop the summary data.
7. When there is a need to reduce acceptance-sampling or other downstream testing to a minimum when the process can be operated in-control, which type of control charts should be preferred?
a) Attributes control chart
b) Variable control chart
c) Both can be used
d) None of the both types can be used
Answer: b
Clarification: When the acceptance sampling is to be reduced to minimum, the variables charts reveal better results and efficiency than the attributes control chart.
8. Which of these does not require SPC implementation?
a) When Specifications change without notice
b) When customer demands both control and capability
c) When process is stable
d) When the process is estimated to reduce its capability in near future
